Step 6 - Install Or Replace Charcoal Filter - Haier HMV1640 Installation Instructions Manual

STEP 6 - INSTALL OR REPLACE CHARCOAL FILTER

NOTE: The charcoal filter is factory installed. Follow these steps to replace a filter or
to install a filter after converting a vented model to a recirculating operation.
1. Remove screws on top of grille using a Phillips screwdriver.
2. Open the door.
3. Pull the grille straight out to remove.
a
a
Charcoal Filter
4. Install the charcoal filter. When properly installed, the wire mesh of the filter
should be visible from the front.
a
a
Insert mesh-side up
5. Replace the grille and the screws.
6. Close the door.
27