Haier HMV1640 Installation Instructions Manual page 21

5. Tighten all bolts.
NOTE: Pull the plate away from the wall to help tighten the bolts.
PREPARE OVERHEAD CABINET
1. Read the instructions on the TOP CABINET template, and then tape the
template underneath the overhead cabinet.
2. Drill the holes following the instructions on the TOP CABINET template.
•
Drill holes for the top support screws.
•
Drill a hole large enough for the power cord to fit through.
•
Drill a cutout large enough for the exhaust adaptor.
ADAPT BLOWER FOR OUTSIDE REAR EXHAUST
1. Remove and save screw that fastens the blower motor to microwave.
2. Carefully pull out the blower unit. The wires will extend far enough to allow you to
adjust the blower unit.
c
a
3. Roll the blower unit 90°.
a
b
c
b
a
b
a
Blower Motor
b
Back of Microwave
c
Blower Motor Screw
a
End A
b
End B
c
Before: Fan Blade Openings
Facing Forward
a
Fan Blade Openings
b
Back of Microwave
b
19