Feed Dog Height - Janome DC5100 Service Manual

SEWING MACHINE

FEED DOG HEIGHT

THE HIGHEST POSITION OF THE FEED DOG SHOULD BE BETWEEN 0.8 TO 0.9 MM FROM THE SURFACE OF
THE NEEDLE PLATE WHEN THE THE PRESSER FOOT IS RAISED.
1. LOWER THE PRESSER FOOT.
2. TURN ON THE POWER SWITCH.
3. REMOVE THE BED COVER.
4. TURN THE HANDWHEEL TOWARD YOU TO SET THE FEED DOG AT THE HIGHEST POSITION.
5. LOOSEN THE SETSCREW(A) AND NUT(B).
6. ADJUST THE FEED DOG HEIGHT BY TURNING THE ADJUSTING SCREW (C).
7. TIGHTEN THE NUT (B) AND SETSCREW (A).
PRESSER FOOT
FEED DOG
MECHANICAL ADJUSTMENT (6)
SETSCREW (A)
NUT (B)
0.80-0.90 MM
SURFACE OF THE
NEEDLE PLATE
E (TO RAISE)
D
(TO LOWER)
ADJUSTING SCREW (C)
23
MODEL DC5100