Advertisement
Take the clear brine tubing that we supplied and slide it through the whole in the brine tank
and into the brine well.
Slip the plastic nut, and the two ferules one black and one white, over brine tubing then
push brass insert and screen into brine tubing as shown in photo below.
Insert tube into top fitting on float shown in photo below and hand tighten then snug it up
with a small wrench. Note: no tape is required this is a compression fitting.
Copyright © 2009 Quality Water Treatment, All right reserved.
Page 6 of 14
rev. 10.29.09
www.qualitywatertreatment.com
Advertisement
