Advertisement
The display should now show C 24.0 as shown in photo below. This indicates the Capacity is
24,000 grains Use the UP or DOWN button to change this value to the size of your system,
and press the Extra Cycle Button once to continue when finished.
The display should now show H 20 as shown in picture below. This indicates the Hardness is 20
grains) Use the UP or DOWN button to change this value to the total hardness of your
water. Then press the Extra Cycle Button once to continue when finished.
The display should now show RS SF as shown in the picture below. This indicates Reserve
Selection is Safety Factor percentage do not change this value, and press the Extra Cycle
Button once to continue.
Page 10 of 14
Copyright © 2009 Quality Water Treatment, All right reserved.
rev. 10.29.09
www.qualitywatertreatment.com
Advertisement
