Advertisement
The display may now show BF 12 as shown in picture below. This indicates the length of the
Brine Refill Cycle during regeneration. Do not change this value, and press the Extra Cycle
Button once to continue. If this value is different, use the UP or DOWN buttons to change
it.
The display may now show FM t0.7 as shown in picture below. This indicates Flow Meter type
3/4" Turbine. Do not change this value, and press the Extra Cycle Button once to continue
if this value is different, use the UP or DOWN buttons to change it.
The system will now exit the Master Programming mode, and the display should now show the
time of day, followed by the new number of gallons remaining, as shown in the picture below.
Change the time of day by pressing and holding the UP or DOWN button until the proper
time setting is shown. There is a PM light indicator to show the difference between AM
and PM times.
Page 13 of 14
Copyright © 2009 Quality Water Treatment, All right reserved.
rev. 10.29.09
www.qualitywatertreatment.com
Advertisement
