Installing The Dvd-Rom Drive - Pioneer dvd-d304 Operating Instructions Manual

INSTALLING THE DVD-ROM DRIVE

Warning about static electricity
Always be sure never to touch the contacts or ports when operating drives.
Warning
Installing add-on drives is a task which requires advanced technical skills and knowledge, and
to ensure safety always be sure to request that installation be performed by trained Pioneer
service personnel. (For further information on how to request such service, please contact a
retail dealer which handles the DVD-D304 drive.)
Be sure to always link the drive positions, leaving no gaps between them. (i.e., first new add-
on drive in drive bay #1, second new add-on drive in drive bay #2, etc.). Note that failing to do
so may result in drives failing to operate properly.
Unused
DRIVE 3
DRIVE 2
DRIVE 1
1. Remove the rear plate covering the
drive bay(s) in which new drive(s) is/
are to be installed, and then remove
the rear panel of the changer.
(The example shown in the accompanying
illustration shows the rear plates to be
removed when installing three drives.)
2. Changer interface cable (left side)
Remove the cable located in the
drive bay where the drive is to be
installed and take the cord clamper
in hand.
Do not remove cables in any other drive
bays.
Power cable (right side)
Unlock all cord holder locks and pull
the cable out towards you.
If any drives have already been installed,
perform the above procedure only for
those drive bays above the drive bays in
which drives have already been installed.
8
En
4
O N
0
4 O
N
0
4 O
N
0
(When three drives are installed)
For Drive No. 4
For Drive No. 3
For Drive No. 2
For Drive No. 1
Cord clamper
4 O
N
0
4
N O
0
4 O
N
0
Cord
holder