Automatic Bluetooth ® Connection (After Successful Pairing) - Hama TWINS Operating Instructions Manual

Note
• The speakers always store the last eight terminal devices
paired.
• The speakers will automatically connect to the last terminal
device paired when it is switched on the next time.
4.5 Automatic Bluetooth
pairing)
• Make sure that your Bluetooth
and Bluetooth
• SMake sure that the speakers are located within the Bluetooth
range of max. 10 metres.
• Switch on the speakers as described in 4.1 Switching on/off
the product.
∆ The status LED (2) of one speaker flashes once at regular
intervals, and the status LED (2) of the other always flashes
twice in quick succession.
• The status LED (2) on each speaker flashes twice in quick
succession.
• An announcement confirms that connection was successful.
∆ The status LED (2) of one speaker flashes once at regular
intervals, and the status LED (2) of the other speaker lights up
constantly.
• The status LED (2) of the individual speaker flashes once at
regular intervals.
Note – Connection impaired
• After the speaker and terminal device have been paired, a
connection is established automatically. If the Bluetooth
connection is not established automatically, check the
following:
• Check the Bluetooth
whether Hama Twins is connected. If not, repeat the steps
listed under Bluetooth
• Check whether your terminal device and the speaker are less
than 10 metres apart. If not, move them closer together.
• Check whether obstacles are impairing the range. If so,
move the devices closer together.
• Check whether the audio cable is connected to the speaker.
If so, disconnect it.
14
®
is activated.
®
settings of your terminal device to see
®
pairing.
®
connection (after successful
capable terminal device is on
®
®
®