Brother PT-P900W Software Manual page 13

(10) Non-printed character setting
The characters specified here are not printed when data is received. Specify 1 to 20 characters.
(11 ) Line feed character setting
The line feed code is used when feeding data to indicate that the following data should be moved to the
next line in a text object. One of the following four line feed codes can be selected, or 1 to 20 characters
can be specified as the line feed code.
1．^CR
2．\0D\0A
3．\0A
4．\0D
(12) FNC1 replacement setting
This setting selects whether or not GS codes, which are included in bar code protocols such as GS1-128
(UCC/EAN-128), are replaced with FNC1 codes.
If the check box is selected, a received GS code is replaced with the FNC1 code. If the check box is
cleared, a received GS code is outputted as is.
(13) Number of copies setting
Specify the number of copies. A number between 1 and 99 can be specified.
(14) Auto cut setting
If auto cutting is selected, the cut operation will be performed after the number of labels specified in (17).
(15) Half cut setting
Specifies half cutting. If the check box is selected, half cuts are made. If the check box is cleared, half cuts
are not made.
(16) Special tape setting
Specifies the special tape (no cut) setting. If the check box is selected, the special tape setting is enabled,
and the auto cut and chain printing settings are disabled (same as being turned off). If the check box is
cleared, the special tape setting is disabled, and the operations for the auto cut and chain printing settings
are performed as specified.
- 7 -
2. P-touch Template Settings Tool User's Guide
P-touch Template Command Reference