Dip Switch Setting - Panasonic CZ-ANC2 Installation Instructions Manual

4. Dip switch setting

Dip switch
How to reach the P.C. board
Remove the fl at-top screw on the bottom of the back case.
Raise the bottom of the control unit, and now remove the unit by sliding it
upward.
The P.C. board on the back of the control unit is now visible.
NOTE Do not force the bottom of the control unit open. Doing so may
fl at-top screw
PCB of the control unit
damage the notch at the top and make it impossible to install the
control unit.
EN
9