Minuteman MR1500 Series Parts And Instruction Manual page 11

TO ADJUST A DRIVE BELT
1. Loosen, but do not remove the 4 bolts, that hold the motor to the frame.
2. Tighten the 2 screws at the back of the frame until the belt is tight.
3. Test and re-adjust the belt until the belt does not slip. Re-tighten the four motor bolts.
WARNING: DO NOT OVER-TIGHTEN THE BELT
SERVICING:
In the event that your BURNISHER requires service, please contact MINUTEMAN:
USA Phone 630- 627-6900 · Fax 630- 627-1130
www.minutemanintl.com
No user serviceable components are employed in this equipment. Do not attempt repairs yourself.
MINUTEMAN will assist you in locating an independent service contractor.
Parts and Instruction Manual - MR1500/MR2000 Burnisher
Page 11