MINUTEMAN’s liability ceases when the carrier picks up the shipment. However, our customer service staff will be happy to furnish any information needed in connection with the claim and will attempt to expedite a resolution.
SAFETY INSTRUCTIONS FAILURE TO COMPLY WITH THE FOLLOWING WARNINGS AND INSTRUCTIONS WILL VOID THE WARRANTY. WARNING! Do not operate the machine unless trained and authorized. Do not allow children or untrained adults to operate this machine. Do not leave the machine when plugged in. Unplug from the outlet when not in use, before servicing, and when changing the brushes or pads.
Page 6
Do not operate machine in flammable or explosive areas. All servicing of MINUTEMAN’s equipment should be performed by a MINUTEMAN authorized service center. Keep hair, loose clothing, fingers and all parts of body away from openings and moving parts.
GROUNDING GROUNDING INSTRUCTIONS: This piece of equipment must be grounded. Should an electrical malfunction occur, grounding provides a path of least resistance for electrical current- reducing the risk of electric shock. This piece of equipment is furnished with a cord that has a grounding conductor and grounding plug. The grounded plug must only be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.
MAINTENANCE MAINTENANCE: This BURNISHER has been engineered and built to require minimum maintenance. But like any machine, it does require some care to keep it in optimum working condition. Careful attention to these maintenance instructions will give you maximum operating performance and life expectancy of the machine.
Page 9
WARNING: PAD INSTALLATION: MACHINE OPERATION: Parts and Instruction Manual - MR1500/MR2000 Burnisher Page 9...
Page 10
8. Once the motor is at full speed, carefully lower the pad onto the floor. Diagram 1 TO MANEUVER THE MACHINE 1. Raise the handle slightly and the machine will go to the right. The higher you raise it, the faster it will go. 2.
Page 11
3. Test and re-adjust the belt until the belt does not slip. Re-tighten the four motor bolts. WARNING: DO NOT OVER-TIGHTEN THE BELT SERVICING: In the event that your BURNISHER requires service, please contact MINUTEMAN: USA Phone 630- 627-6900 · Fax 630- 627-1130 www.minutemanintl.com No user serviceable components are employed in this equipment.
Screw, 10-32 X .25 in D11507-2 Cord Hook Clamp H12069 Label, 2000 RPM, Saturn D11507 Cord Hook Body H13699 Label, MINUTEMAN, White C11558 Locknut, Black Oxide, Thin D11496B Switch Box Cover, Black C11502 Socket Cap Screw, .375-16 X 2.5 in...
MR1500-115 BOM BILL OF MATERIAL ITEM PART # QTY DESCRIPTION ITEM PART # QTY DESCRIPTION B02196 Light, Motor Carbon Brush C02305 Cap Nut, .5 in Push-on Wear C11916 Screw, 10-32 X .375 Phillips C11558 Locknut, .375-16 D11490B- Drip Cover, Black w- Hole for D11562 Axle, Wheel Green Light...
Page 18
MR1500-220 19 20 22 27 28 MR1500-220 8-18-16 Parts and Instruction Manual - MR1500/MR2000 Burnisher Page 18...
MR1500-220 BOM BILL OF MATERIAL ITEM PART # QTY DESCRIPTION ITEM PART # QTY DESCRIPTION B02196-1 Light, Motor Carbon Brush C02305 Cap Nut, .5in Push-on Wear C11916 Screw, 10-32 X .375 Phillips C11558 Locknut, .375-16 D11490B-H Drip Cover, Black w- Hole for D11562 Axle, Wheel Green Light...
Page 20
MR2000-115 19 20 22 27 28 MR2000-115 7-28-16 Parts and Instruction Manual - MR1500/MR2000 Burnisher Page 20...
MR2000-115 BOM BILL OF MATERIAL ITEM PART # DESCRIPTION ITEM PART # DESCRIPTION B02196 Light, Motor Carbon Brush Wear C02305 Cap Nut, .5in Push-on C11916 Screw, 10-32 X .375 Phillips C11558 Locknut, .375-16 D11490B-H Drip Cover, Black w- Hole for D11562 Axle, Wheel Green Light...
Page 22
MR2000-220 19 20 22 27 28 MR2000-220 7-28-16 Parts and Instruction Manual - MR1500/MR2000 Burnisher Page 22...
MR2000-220 BOM BILL OF MATERIAL ITEM PART # DESCRIPTION ITEM PART # DESCRIPTION B02196 Light, Motor Carbon Brush Wear C02305 Cap Nut, .5in Push-on C11916 Screw, 10-32 X .375 Phillips C11558 Locknut, .375-16 D11490B-H Drip Cover, Black w- Hole for D11562 Axle, Wheel Green Light...
Page 26
“Excellence Meets Clean” Minuteman is a Full Line Manufacturer of Sweepers and Scrubbers, for Industrial Facilities. 14N845 U.S. Route 20, Pingree Grove, IL 60140 USA Phone (800) 323-9420 - www.minutemanintl.com A Member of the Hako Group 988753 Rev * 08/16...