Procedure - Daewoo EGSP-130E Technical & Service Manual

Test Program Procedure
Initialization
Inlet valve
Washing pump
Dispenser
Heating element
Drain pump
Pause
Inlet valve
Washing pump
Pause
Washing pump
Drain pump and
Regeneration
valve
Finish
00: Power up and stand by
01: Open inlet valve, inlet water till the water level pressure
switch act and continue inletting water for 15 sec.
02: Start washing pump, check water level pressure switch. If the
switch reset, inlet supplementary water until switch act, and
then continue washing for 13 sec.
03: Open dispenser for 60 sec.
04: Run washing pump and heater until water temperature reached
05: Run drain pump till water level pressure switch reset, and
06: Pause for 15 seconds.
07: Open inlet valve till water level pressure switch act, and
08: Run washing pump to wash for 3 minutes.
09: Pause for 5 seconds.
10: Run washing pump to wash for 3 minutes.
11: Run drain pump till water level pressure switch reset, and
continue draining for 15 sec.
12: Buzz one sound, and then the machine stops.

Procedure

->
Test Program
47