Table of Contents
Advertisement
Capping station ("Cleaning the Wiper and Cap" Chapter 5 of the Operation Manual)
The surrounding area of the cap is also liable to be stained by the dust and ink. It is recommended to clean the
head frequently using the cleaning liquid for maintenance suitable for the ink used to avoid the stains on the
head.
Cleaning Solution 200 for Solvent Ink kit (Product No. SPC-0369)
Wiper ("Cleaning the Wiper and Cap" Chapter 5 of the Operation Manual)
On the wiper, the ink, dust and paper powder are liable to accumulate. Check the state of the wiper and if it is
stained, clean it.
Wiper kit 33S: Product No. SPA-0134
Further, in the cases as explained below, replace the wiper with the new one in accordance with
"Replacing the wiper" on Chapter 5 of the Operation Manual.
When the wiper is deformed
When the stuck ink can not be wiped off
When the warning for wiper replacement is indicated
(When the number of wiping exceeds the set level. Refer to "Changing the Time When a Warning about
Wiper Replacement Is Issued" Chapter 5 of the Operation Manual)
1
2
Capping
station
1
2
Wiper
Move the carriage.
• Press the
(FUNCTION / MAINTENANCE / CR.MAINTENANCE)
Clean the cap.
• Dip the clean stick into the cleaning liquid for maintenance
and wipe off the cap.
Move the carriage.
• Press the
(FUNCTION / MAINTENANCE / CR.MAINTENANCE)
Clean the wiper.
• Dip the clean stick into the cleaning liquid for maintenance
and wipe off the wiper.
3
key and run [CR.MAINTENANCE].
Cap
key and run [CR.MAINTENANCE].
Wiper
Advertisement
Table of Contents
