Electrolux TINSEB493MRR2 Use & Care Manual page 5

Table of Contents

Advertisement

Improper use of the grounding
plug can result in a risk of electric shock.
Electrical
Requirements
The electrical requirements
are a 120 volt 60 Hz, AC only, 15 amp. or more protected electrical supply. It
is recommended
that a separate circuit serving only this appliance be provided.
The oven is equipped with a 3-prong
grounding plug. It must be plugged into a wall receptacle that is
properly installed and grounded.
A short power-supply
cord is provided to reduce risk of becoming entangled
in or tripping over a longer
cord. DO NOT USE AN EXTENSION CORD. If the power supply cord is too short, have a qualified electri-
cian or serviceperson
install an outlet near the appliance.
NOTES:
1. If you have any questions about the grounding or electrical instructions,
consult a qualified electrician
or serviceperson.
2. Neither Electrolux nor the dealer can accept any liability for damage to the oven or personal injury
resulting from failure to observe the correct electrical connection
procedures.
Federam Communications
Commission
Radio Frequency
mnterference Statement
(U.S.A. Only)
This equipment generates and uses ISM frequency energy and if not installed and used properly, that is
in strict accordance
with the manufacturer's
instructions,
may cause interference to radio and television
reception.
It has been type tested and found to comply with limits for ISM Equipment pursuant to part
18 of FCC Rules, which are designed to provide reasonable
protection
against such interference
in a
residential installation.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause interference to radio or television reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to correct the interference by one or more of the following:
Reorient the receiving antenna of the radio or television.
Relocate the microwave oven with respect to the receiver.
Move the microwave oven away from the receiver.
Plug the microwave oven into a different outlet so that the microwave oven and the receiver are on
different branch circuits.
The manufacturer
is not responsible for any radio or television interference
caused by unauthorized
modification
to this convection
microwave
oven. It is the responsibility
of the user to correct
such
interference.

Advertisement

Table of Contents
loading

Table of Contents