Attaching The Covers For Supply And Exposure Unit - Konica Minolta DRYPRO 771 Installaton Manual

Ch.2 Unpacking and Installation
2.4.6 Attaching the Covers for Supply and Exposure Sections
As soon as the procedures in 2.4.2 through 2.4.5 are completed, attach the covers for supply and exposure
sections.
The procedure for attaching the supply unit cover is detailed below.
1) Bring the upper edge of the supply unit cover into contact with the main
body.Ensure that the groove at the top left of the supply unit cover fits under
the bar that secures the main body and front cover.
2) Bring the lower edge of the supply unit cover into contact with the main body.
3) Ensure that the two hooks located on the back of the supply unit cover latch
into the corresponding slots on the main body.
4) Secure the supply unit cover to the main body using the six screws provided.
1
DRYPRO MODEL 771 INSTALLATION MANUAL Ver.1.00 2003.10
DRYPRO MODEL 771 INSTALLATION MANUAL Ver.1.00 2003.10
1
Attach the cover for supply section.
• Screw the cover to the main body with six screws
(TP screws, M3x6).
1
Attach the cover for supply section.
• Screw the cover to the main body with six screws
(TP screws, M3x6).
< 36 >
2
< 36 >
3