The following checklist will assist in the correction of most problems which you may encounter with
Before going through the checklist below, refer to the connection and operating procedures.
The sound is distorted.
Preset tuning is not possible.
The stations cannot be
The sound is hampered by
Automatic tuning is not possible.
• Adjust the volume with the
• Set the fader control to the centre position for two-speaker
The tape head is contaminated.
n Clean the head with a commercially available dry-type
• Memorise the correct frequency.
• The broadcast signal is too weak.
Connect an power aerial control lead (blue) or accessory power
supply lead (red) to the power supply lead of a car's aerial
(When your car has built-in FM/MW/SW aerial in the rear/side
The broadcast signal is too weak. n Use manual tuning.