Fujitsu AS*7A Technical Manual page 131

Decide the mounting position with the customer as
follows:
1. INDOOR UNIT
(1) Install the indoor unit level on a strong wall which is
not subject to vibration.
(2) The inlet and outlet ports should not be obstructed :
the air should be able to blow all over the room.
(3) Install the unit near an electric outlet or special
branch circuit.
(4) Do not install the unit where it will be exposed to
direct sunlight.
(5) Install the unit where connection to the outdoor unit
is easy.
(6) Install the unit where the drain pipe can be easily
installed.
(7) Take servicing, etc. into consideration and leave the
spaces shown in Fig. 1. Also install the unit where
the filter can be removed.
Fig. 1
Left side
5 cm or over
150 cm
or over
150 to 200 cm
6 cm or over
Right
side
5 cm
or over
– 130 –
2. OUTDOOR UNIT
(1) If possible, do not install the unit where it will be
exposed to direct sunlight. (If necessary, install a
blind that does not interfere with the air flow.)
(2) Do not install the unit where a strong wind blows or
where it is very dusty.
(3) Do not install the unit where people pass.
(4) Take your neighbors into consideration so that they
are not disturbed by air blowing into their windows
or by noise.
(5) Provide the space shown in Fig. 2 so that the air
flow is not blocked.
Also for efficient operation, leave open three of the
four directions front, rear, and both sides.
Fig. 2
30 cm
or over
60 cm
or over
80.4 cm
60 cm
or over
30 cm
or over
40 cm
or over