NINCOAIR 190 EVO MICRO Handbook page 7

TRIM ADJUSTMENTS:
Throttle Trim Adjustment
If your rotors start to spin without adding any throttle or if they do not spin when you do add throttle, your throttle trim needs to be adjusted. If it
start to spin without any throttle, push the throttle button down until they stop. If they do not spin, even when you add throttle, push the throttle trim
button up until the blades start spinning when the throttle is pushed forward.
Turn Trim Adjustment
If while hovering, your Helicopter 's nose begins to rotate when no yaw control input is being added,
you will need to adjust the yaw trim. If nose rotates to the left, push to the right until it stops. If nose
rotates to the right push the trim button to the left until it stops.
Elevator Trim Adjustment
If, while hovering, your Helicopter begins to move forward or back when no pitch control input is being added, you will need to adjust the
forward/back. If it moves forward, push left button until it stops. If it moves backward, push right one until it stops.
Aileron Trim Adjustment
If your Helicopter begins to move left or right when no roll is being added, you will need to adjust the roll trim. If it moves left, push the right button
until it stops. If it moves right, push the left one until it stops.
FLIGHT CONTROL (190 EVO MICRO – 190 PHOENIX MICRO):
Helicopter take off:
The helicopter can take off after trimming.
1. Place the helicopter in the middle of the room over a straight surface.
2. Push the throttle stick up, the rotating speed will increase. Push up quickly before the helicopter takes off the ground.
3. Focus on the helicopter, do not look at the transmitter
4. Practice the up, down and stabilization movements.
7
NINCOAIR is brand of NINCO DESARROLLOS S.L.
Crta. de L'Hospitalet 32
08940 Cornellà - Barcelona - Spain
CIF B-60307725 - www.nincoair.com
HANDBOOK
ENGLISH