Table of Contents
Advertisement
Storing
the Refrigerator
.....................................
Vacations
Moving
If you will be gone for a month or less, leave the con-
When moving, follow steps a-d under Vacations. In
trois at the usual settings,
addition, remove and carefully pack any items that are
During longer absences:
easily removable. Ship the refrigerator in an upright
a) remove all food,
position with the doors taped shut.
b) shut off the ice maker (if installed) and the valve
where you tapped into the water line to supply the
refrigerator,
c) disconnect the refrigerator from the electrical outlet,
d) clean and dry the refrigerator thoroughly,
e) leave the doors open to prevent odors.
Care
and Cleaning
........................
.......................
Refer to the chart on the following page for specific
No Clean
TM
commercial-duty
refrigerator cleaning guidelines.
Condenser
Disconnect
th_
A clean condenser means more efficient refrigerator
operation. Thanks to the unique design of the No
;.
Clean
TM
condenser there's no longer a need for routine
____C-leanlnn
Under the ....._,.ReCr;nera*orcondenser
cleaning in normal home usage surroundings.
Some operating environments may be particularly dusty
Your refrigerator can be rolled out for cleaning the floor
or greasy. In these situations, the condenser can be peri-
underneath. Raise the locking feet if engaged (see page
odically cleaned to insure maximum efficiency.
3). Pull the refrigerator straight out from the wall.
Replacing a Light Bulb
ii
as
Always
use a standard
40 or 60 watt appliance
bulb.
Refrigerator
Freezer
There are two light bulbs located under the top of the
The freezeR light is located on the back wall, near the
refrigerator compartment, on either side of the Dual
upper right corner.
Cool
TM
control housing.
To remove the bulb cover:
• Carefully grasp the lightbulb by reaching behind the
• Grasp the top and bottom of the bulb cover. Press in
bulb cover,
the areas of the attachment tabs, applying enough
• Unscrew the light bulb and replace,
pressure to unhook the tabs. At the same time, pivot
the cover down and remove.
• Unscrew the lightbulb and replace.
• Replace the bulb cover by pivoting it back into place
and snapping the tabs into the appropriate slots.
13
Advertisement
Table of Contents
