Table of Contents
Advertisement
Entering Identity Information
After accessing your unit for the first time, use the Change Identity screen to determine
SNMP administrative system information that will be displayed on the Identity screen of
the Status branch. To access the Card Identity screen, follow this menu selection
sequence:
Main Menu
Configuring the Unit
Configuration option settings determine how the unit operates. Use the Configuration
menu branch to display or change configuration option settings.
The unit is shipped with factory settings in the Default Factory Configuration area. If the
factory default settings do not support your network's configuration, customize the
configuration options for your application.
A DSLAM-to-DSLAM configuration requires that the unit at one end of the link be set to
NTU mode. DSLAM-mounted Hotwire termination units default to LTU mode.
Accessing and Displaying Configuration Options
To display the configuration options, you must first load a configuration option set into
the edit area.
To load a configuration option set into the configuration edit area, follow this menu
selection sequence:
Main Menu
Make a selection by placing the cursor at your choice and pressing Enter.
If you select . . .
Current
Configuration
Configuration
Loader
Default Factory
Configuration
Control
Change Identity
Configuration (Load Configuration From)
Then . . .
The selected configuration option set is loaded and the
Configuration Edit/Display menu screen appears.
The Configuration Loader screen is displayed allowing you to
upload or download configurations from a TFTP server.
The selected configuration option set is loaded and the
Configuration Edit/Display menu screen appears.
10
Advertisement
Table of Contents
