Table of Contents
Advertisement
Hotwire TDM SDSL Termination Units
Hotwirer 8775 and 8785 TDM SDSL Termination Units are circuit card assemblies
comprising four Time Division Multiplexer Symmetric Digital Subscriber Line
(TDM SDSL) ports and four synchronous ports. When the Hotwire 87xx TDM SDSL
Termination Unit is used in a Hotwire 8600 or 8800 Series Digital Subscriber Line
Access Multiplexer (DSLAM), it transports up to 2048 kbps signals over traditional
twisted-pair telephone wiring.
Installation Overview
Installation and configuration of the Hotwire 87xx TDM SDSL Termination Unit
consists of:
H
Installing the unit in the DSLAM.
H
Connecting to the Data Terminal Equipment (DTE).
H
Connecting to a Main Distribution Frame (MDF).
H
Providing initial unit identity information or changing existing identity information.
H
Configuring the unit using the Configuration Edit menus.
Before you install the unit, read the Important Safety Instructions in the appropriate
DSLAM manual.
Planning the Installation
Review the following list to help plan for the installation.
-
Obtain the applicable cables; refer to Cables You Need.
-
Make sure the Hotwire DSLAM is installed and power is supplied to the chassis.
-
After the unit is installed, there are configuration procedures that must be
performed before you can begin to use it. Refer to the User's Guide if you require
detailed configuration procedures.
2
Advertisement
Table of Contents
