1. #2 Phillips screwdriver 3. Razor knife or similar 5. Awl or similar tool 7. Audiovox Series 640/650 Video Module FOR USE IN VEHICLES EQUIPPED WITH FACTORY INSTALLED REAR AIR CONDITIONING and WITH FACTORY OVERHEAD CONSOLE ONLY. INSTALLATION INSTRUCTION # 44-0024B...
Page 2
MATERIALS PROVIDED FOR INSTALLATION: ITEM Description SCREW, # 8 X 3/4 HWH SCREW, # 8 X 11/4 PPH SCREW, #10 X 3/4 HWH SCREW, 6-32 X 3/4 PPH WASHER, 3.5 mm MOUNTING BRACKET CONSOLE INSTALLATION INSTRUCTION # 44-0024B I. PREPARATION OF VEHICLE INTERIOR May 19, 1999 Printed in the U.S.A.
Page 3
FIGURE 1 2. Disconnect wiring harness from console. See Fig. 2. Lay console in a safe place. Remove and retain (2) two O.E.M. screws from plastic bracket. Transfer Velcro tape from console to identical location on new console (item 4 pg 2). FIGURE 3 Remove and discard front mounting screw from overhead console and pull downward to...
4. Install mounting bracket (item 6 pg 2) and secure using (2) two # 10 x 3/4" screws (item 1 pg 2) in bottom flange that aligns with dimples in roof brace. Secure top flanges using (2) two # 8 x 3/4" screws (item 3 pg 2).
Page 5
6. Using the diagram in Figure 6, construct a jumper harness that will connect the vehicle’s dome light wire harness to the new dome lights in video system. Make sure that lights in video system operate from the door jamb switch. FIGURE 7 Caution: Do not overtighten screws.
Page 6
8. Release video screen from locked position. Lower video screen to viewing position for access to mounting locations in top of video system housing. 9. Raise video system into approximate position and connect all wiring to components. Route video cable through notch in mounting bracket.