User Instructions - Heatrae Sadia HOTFLO Installation And User Instructions Manual

11.0 ACCESSORIES
The heater can be used to supply several hot water outlets via conven-
tional taps. It is not recommended for supplying a shower. Individual
site demands should be considered when choosing capacity and the
number of outlets to be served.
A Thermostatic Blending Valve can be used in conjunction with this
unit. Accessory Pack U3 (code no. 95 970 354) is recommended. Follow
the installation instructions supplied with the valve for connection to the
system.

12.0 USER INSTRUCTIONS

12.1 The Hotflo unvented heater stores water at the temperature set on
the adjustable thermostat. This can be set to give temperatures in
the range of 10 to 70
heater is not in use for long periods during the winter months, do
not switch off the electrical supply and set the thermostat to its
minimum position. N.B. This will not protect other system
pipework.
12.2 The indicator light will be illuminated when the unit is heating.
12.3 To ensure the heater continues to operate at its optimum perform-
ance it should be periodically maintained in accordance with the
instructions given under the Sections headed MAINTENANCE.
12.4 IMPORTANT NOTES TO USER
Do not block or restrict the discharge from any safety valve
fitted.
Do not tamper with any safety valve fitted.
If water discharges from any safety valve fitted, switch off the
electrical supply to the unit immediately. Contact the Heatrae
Sadia Servive Team (Tel: 01603 420330) or an approved
installer. Do not turn the electrical supply on again until the
unit has been checked and approved by a qualified installer.
o
C. To avoid any risk of freezing when the
11