The Write Menu; Storing A Setup; Storing A Sound - Quasimidi POLYMORPH Operating Instructions Manual

The write menu

The write menu
The write menu is about storing data internally and externally via MIDI, and also initializing the
POLYMORPH.

Storing a setup

The setup memory saves all updated settings with exception of the system menu. You can store the
settings of all four parts, all effect settings of the parts and the complete sequencer data easily in the
64 memory banks.
Do the following to store:
1.)
2.)
3.)
4.)
5.)
6.)
7.)
8.)

Storing a sound

In sound memory are all the sound parameters of a part and the complete current effect section
from distortion, EQ, FX-1 and FX-2 stored. All user memory banks U 001 - U 128 are available.
No sounds can be stored into the sound memory of the setups, that's in banks A - D. These
memory banks are only for saving the setups.
Push [WRITE] to reach the menu.
Select menu page 1 of the write menu by using [PAGE<>]. The display shows:
L1> Store setup?
[ok]
Push [F1] to start the storage of the setup. The display shows:
Name:xxxxxxxx
[ok] [cancel]
Now you can give a name to your setup. With [PAGE<>] you can select the character
position and with <VALUE> select the corresponding characters/special symbols. The
name can also be entered in over a connected MIDI keyboard. Look in the appendix for
the character table.
If you are satisfied with the name, push [F1] again. If you want to leave the menu without
storing, push [F2] then [EXIT]. In the first case the following message is in the display:
to xx (xxxxxxxx)
[ok] [cancel]
With <VALUE> you can select the target memory that will be overwritten with the new
setup. The name of the designated setup will be shown on the display.
With [F1] the storage will take place, with [F2] you can still cancel storing.
With [EXIT] you can leave the write menu.
48