Modulations Wheel Assignment: Menu; Aftertouch Assignment: Menu Pages 6-7 - Quasimidi POLYMORPH Operating Instructions Manual

Modulations wheel assignment: menu page 4-5
Menu pages 4 and 5 allow you to assign POLYMORPH controllers to the modulation wheel (MIDI
controller 1). On menu page 4 you can select the modulation destination and on menu page 5 you
can change the strength and polarity of the control. Go to the menu page 4 to select the
modulation destination:
This display means the modulation wheel it is not yet assigned to a parameter. However the
following parameters can be selected with <VALUE-TEMPO> wheel:
Panorama
Detune 2
Level 3
HP Reso
Pitch EG
PWM Depth
LFO3 Rate
FX1 Feedback
FX2 Level
FX2 Depth
Distortion Resonance
On menu page 5 you can select the modulation depth for the chosen parameter.
Here follow the selection possibilities:
+50 Full deflection of the modulation wheel makes a positive change of the parameter value.
The size of the change is 50% of the full value range.
+100 Full deflection of the modulation wheel makes a positive change of the parameter value.
The size of the change is 100% of the full value range.
-50 Full deflection of the modulation wheel makes a negative change of the parameter value.
The size of the change is 50% of the full value range.
-100 Full deflection of the modulation wheel makes a negative change of the parameter value.
The size of the change is 100% of the full value range.

Aftertouch assignment: menu pages 6-7

These pages assign controllers for the monophonic Aftertouch data. They are otherwise the same
as for the modulation wheel settings described above. Instead of modulation destination and the
strength of the modulation wheel, select the corresponding parameter of the aftertouch (keyboard
pressure).
The Synthesizers of the POLYMORPH
Edit Part1 CONTR
<4> MW:Not assgn
Wave 1
Level 2
FilterDrv
LP cutoff
PWM EG
FM Rate
LFO3 Depth
FX1 Rate
FX2 Feedback
Distortion Gain
Edit Part1 CONTR
<5>MWDepth: +100
Edit Part1 CONTR
<6> AT: Not assign
Edit Part1 CONTR
<7l ATDepth: +50
37
Level 1
Detune 3
HP cutoff
LP Reso
PWM Rate
FM Depth
FX1 Level
FX1 Depth
FX2 Rate
Distortion cutoff