Midi Output Filter - Quasimidi POLYMORPH Operating Instructions Manual

The System Menu
Receiving a Setup program change. When this parameter is "ON", the setups can be selected over
MIDI. The setup changes are received on the MIDI channel that is 4 channels above the master
channel. In the factory setting the master channel is on 1, the setups let themselves be switched
accordingly on MIDI channel 5.
Receiving single program changes. When this parameter is "ON", the single sounds can be switched
over MIDI.
Receiving sound parameters. The POLYMORPH sends all control changes using a conventional
MIDI controller number. To also receive these messages, RxParam: must be ,,ON".

MIDI output filter

On menu pages 11-14 you can choose what MIDI data from the POLYMORPH will be sent out.
You decide in this menu, if the POLYMORPH clock information is sent or not. Only when it is sent
can the other instruments like the RAVE-O-LUTION 309 run in synchronized Tempo with the
POLYMORPH.
Here you decide if the POLYMORPH sends the program change messages of its setup changes
over MIDI. In the position "ON" it sends every change of a setup as a corresponding program
change.
Here you select whether the POLYMORPH single program changes are sent by MIDI or not, when
<SOUND> is turned, and it is in the single sound mode.
Here you can decide if the MIDI controller data of the control knobs will be sent over MIDI or not.
Edit System/MIDI
<8> RXSetChg: OFF
Edit system/MIDI
<9> RxPrgChg: ON
Edit System/MIDI
<10> RxParam: ON
Edit System/MIDI
<11> TXClock: ON
Edit System/MIDI
<12> TxSetCh: OFF
Edit System/MIDI
<13> TxPrgCh: ON
Edit System/MIDI
<14> TxParam: ON
46