Siemens DO05705 Installation & Operating Instruction page 21

Usage (for the customer)
Before using the appliance, please read the instruc-
tions carefully and observe them!
Important: The appliance may never be exposed to frost!
Risk of electric shock!
If a fault occurs, immediately disconnect the plug
from the power supply!
Immediately shut off the cold water supply to the
appliance should it leak
Please read and observe the detailed safety instructions
at the start of these instructions!
Operation
The small water heater heats and stores drinking water up to
approx. 85 °C.
Setting the water temperature
The required outlet temperature from 35 °C to 85 °C can
be set with the rotary selector switch.
or:
Set the required fixed outlet temperature ( A):
Frost protection
I Approx. 40 °C (soft lock-in)
e Conserve energy approx. 60 °C (soft lock-in)
III Hot water approx. 85 °C
Undersink appliances DO05705, DO05755, DO05755K, DO3170D5, DO3175D5 and DO05705CH
A
Oversink appliances DO05805, DO05855, DO3185D5 and DO05805CH
A
en
B1
e
~ 60 °C
e
B1
~ 60 °C
The pilot lamp lights up during heat up.
Water drips out of the tap with oversink appliances.
The appliance with be covered more quickly with limescale
at higher temperatures.
Tip: Set the rotary selector switch to "e" to operate the appli-
ance economically and to reduce the effects of limescale.
Note: If the appliance has not been used for an extended
period, e. g. during a holiday, allow the water to briefly heat
up to stage "III".
Limitation of the water temperature
Limit the outlet temperature to avoid scalding with hot
water:
Set the rotary selector switch to " ".
Open the cover of the rotary selector switch.
Select between "I" = approx. 40 °C ( B1) or "e" = approx.
60 °C (B2).
Close the cover.
Switching off
Set the rotary selector switch to " " (A). The heating is
switched off.
~ 40 °C
B2
I
~ 40 °C
I
B2
21