Trouble Shooting - Belling BC60S Instruction Manual

Fault
Light on, but motor
does not work.
Both light and motor
do not work.
Oil leakage.
Vibration.
Insufficient suction.
The machine inclines.
Electrical Diagram

Electrical diagram see label on main body of the actual product.
Cause
The blades are blocked.
The capacitor is damaged.
The motor is damaged.
The internal wiring of motor is cut off /
disconnected. An unpleaseant smell
may be produced.
Apart from the above mentioned, check the following:
Light damaged.
Power cord loose.
Outlet and the air ventilation entrance
are not tightly sealed.
Leakage from the connection of
U-shaped section and cover.
The blade, if damaged, can cause
vibrating.
The motor is not tightly fastened.
The cooker hood is not tightly fixed.
The distance between the cooker
hood and the cooker top is too large.
Too much ventilation from open doors
or windows.
The fixing screws are not tight
enough.
The hanging screws are not tight
enough .

Trouble Shooting

Solution
Replace capacitor.
Replace motor.
Replace motor.
Replace lights.
Connect the wires as per the
electric diagram.
Take down the outlet and seal with
glue.
Take U-shaped section down and
seal with soap or paint.
Replace the blade.
Fasten the motor tightly.
Fixed the cooker hood tightly.
Readjust the distance.
Choose a new place to install the
appliance or close some doors /
windows.
Tighten the fixing screw and make
it horizontal.
Tighten the hanging screw and
make it horizontal.
9
2 2 2