Modify Params - Modifying Compr./Motor Settings - Atlas Copco ga37 User Manual

User manual
10 Modify Params – modifying compr./motor settings
Function
The menu allows the operator to program:
- Compr. / motor settings
- Parameters, see section 11
- Protection settings, see section 12
- Service plan settings, see section 13
- Clock settings, see section 14
- Configuration settings, see section 15
Modifying compr./motor settings
Function
To modify a number of settings as mentioned in Fig. 4.1.
Procedure
1. Starting from the Main screen (see section 4.2):
- press the key Menu (F1)
- press the ↓ key until the option Modify Params is followed by a horizontal arrow
- press the tabulator key (2) to activate the menu
2. The first option (Compr./motor) will be followed by a horizontal arrow.
3. Press the tabulator key (2): the first item (Setpoint 1) and its setting will appear.
4. Use the ↓ key to scroll until the parameter to be modified is followed by a horizontal arrow.
Modifying the net pressure setpoints
If desired, the operator can program two setpoints (Setpoint 1 and setpoint 2).
1. Consult the steps above to select Setpoint 1.
2. The screen shows that the current setting is 7.0 bar(e). To modify this setting, press the key Mod
(F2); the setting will blink.
3. The key Lim (F2) can be used to find out the limitations for the parameter. Use the ↓ or ↑ arrow
key to change the value.
4. Press the key Prog (F1) to program the new setting or the key Canc (F3) to cancel the
modification operation.
5. If required, the procedure to modify setpoint 2 is similar to the description above.
2920 1456 03 16