Changing The Drum Light; Moving Care; Vacation Care - Kenmore 90 Series Gas Owner's Manual And Installation Instructions

CHANGING THE DRUM LIGHT
The dryer light automatically turns on
inside the dryer drum when you open
the door.
!/
To replace bulb:
STEP 1. Unplug power supply cord or
turn off electrical power supply.
STEP 2. Open the dryer door. Remove
the screw that holds the lens in place.
i
i
STEP 3. Remove the lens by pulling
it down and away from drum.
STEP 4. Push tab to allow bulb to
swing out.
STEP 5. Check that the lightbulb is
screwed in tightly. The vibration ofthe
dryer may cause the bulb to come loose.
If this is not the problem, remov e the
light bulb by turning it ('ounterclockwise.
IMPORTANT: Replace the, bulb with
a 25-watt, 120VA.C. bulb only.
STEP 6. Install light bulb by turning it
clockwise.
STEP 7. Push bottom of light and socket
assembly in until tab locks.
STEP 8. Place the top of the lens onto
the top of the holder. Rotate the bottom
of the lens down until it is in place.
Replace screw. NOTE: It is very impor-
tant that the lens is replaced properly.
STEP 9. Plucj in power supply cord or
turn on electric supply.
MOVING CARE
• Unplug power supply cord or turn
off electrical power supply.
• Close shut-off valve in gas supply line.
• Disconnect gas supply line pipe and
remove fittings attached to dryer pipe.
• Cap the open fuel supply line.
• Make sure leveling legs are secure
in dryer base.
• Use masking tape to secure dryer
door.
VACATION CARE
• Unplug power supply cord or turn
off electrical power supply.
• Wash lint screen.
34