Mobile Home Exhaust Requirements - Kenmore 90 Series Gas Owner's Manual And Installation Instructions

MOBILE HOME EXHAUST
RP'QUIREMENTS
• T[ne dryer must not be installed where it
will be exposed to water and/or weather.
Proper operation of dryer cycles requires
temperatures above 45°E At lower tem-
peratures, the dryer may not shut off at
the end of automatic cycles. Drying times
will be extended.
• Use, at least, the minimum installation
spacings described on page 10. This will
e_nsure you have an adequate clearance
for service and proper operation includ-
irtg flow of combustion and ventilation air,
and that you have a sufficient distance
from combustible construction.
• Special provisions must be made for the
introduction of outside air into the dryer
when installed in a mobile home. The
area of any opening for the introduction
of outside air (such as a nearby window)
should be at Heasttwice as large as the
dryer exhaust opening.
This dryer is suitable for mobile home
installations. The installation must conform
to the Manufactured Home Construction
and Safety Standard, Title 24 CFR, Part
3280 (formerly the Federal Standard for
Mobile Homes Construction ,and Safety,
Title 24, HUD Part 280).
For mobile home use, gas dryers must
be securely fastened to the floor. Order
Mobile Home Installation Kit 346764
from your Sears store or Sears Service
Center. Kit includes the necessary fast-
ening hardware and detailed installation
instructions. Exhaust system hardware
is also available through your Sears
store or Sears Service Center.
• Dryer exhaust vent must not
be connected or secured with
screws or other /
devices which
extend into the _ t-
interior of the duct.
I
i
• A gas dryer must i
be exhausted t
outdoors. The _
exhaust vent must
be securely fastened
to a non-combustible portion
of the mobile home structure
and must not terminate beneath
the mobile home.
11