Yamaha BRX-610 Owner's Manual page 48

Dt;[o111_l=g."t_[olo_lth_[_
No picture. Make sure that the cables are connected correctly. 13
Make sure that the connected TV is set to the correct 13
input.
Connect this unit to the TV with VIDEO jack using 13
the supplied video pin cable.
If picture is still not displayed with this unit
connected to the VIDEO jack, press and hold
_-/| | and _=_ on the front panel simultaneously
for around 5 seconds when no disc is inserted and
playback is stopped to switch NTSC/PAL.
TV system is set incorrectly. Press and hold =,,-/ill | and _. on the front panel --
simultaneously for around 5 seconds when no disc is
inserted and playback is stopped to switch NTSC/
PAL. Set resolution properly again when connecting
through HDMI (p. 38).
The power is The sleep timer is set. This is not malfunction. Turn on this unit and play 31
suddenly turned off.
the source again.
[Auto Power Oft'] is set to [On]. Set [Auto Power Oft'] to lOft']. 3(5
Sound is heard from Incorrect cable connections. Connect the cables properly. If the problem persists, 11
the speaker on one
the cables may be detective.
side only.
There is noise This unit is too close to tile digital or Move this unit farther away fronl such equipment. --
interference from
high-frequency equipment.
digital or radio
frequency
equipment.
This unit makes a _ These sounds are not malfunctions of this unit but --
snapping sound _
are normal operating conditions.
when starting
playback or loading a
disc.
No sound from the Tile subwoofer is not connected properly. Check that tile subwoofer is connected properly. 11
subwoofer.
The level of subwoofer is low. Increase the subwoofer le_.el with the SW 7
(subwoofer) + button.
Sound from the The subwoofer output level from the unit Decrease the subwoofer output level with the SW 7
subwoofer is too high. (subwoofer) - button, then increase the subwoofer
connected to the
level with the control on the subwoofer itself.
SUBWOOFER pre-
out jack is distorted.
The system settings When [HDMI Control] is set to [On], Set [HDMI Control] to [Off] or set the system again 3(5
change operations of the TV (t_r example, by using its remote control.
automatically,
changing channels, etc.) changes the
system settings.
The HDMI control [HDMI Control] is set to [Oft']. Set [HDMI Control] to [On]. 36
function does not
work properly. The HDMI control function is disabled Refer to the manual supplied with your TV and --
on your TV. check the setting.
The automatic
The TV does not support the automatic Set [Lip Sync] to lOft] and then manually adjust the 39
lipsync is not lipsync, audio output delay.
effective even [Lip
Sync] is set to [Auto].
Incorrect cable connections.
44
En