Assembly - ParaBody ex 350 Assembly Instructions Manual

358 EX350 A:~SEtvlBLY INSTRUCTIONS
,THANK YOU
.;
:."
" : ~2..-~.-_:.
.
. ." ....~ ~---~..
FOR PURCHASING THE ~ PLEASE SAVE THESE ASSEMBLY INSTRUCTIONs
FOR YOUR PERSONAL REFERENCE, AND ADDITIONAL SERVICE INFORMATION.,~,~"
. ¯
***IMPORTANT***
"::
THE EX350 MUST BE ASSEMBLED ON A FLair, LEVEL SURFACE TO ASSURE ITS:''"~
FUNCTION.
PARABODY INC. STRONGLY RECOMMENDS THAT THIS PRODUCT BE ASsEMBI~ED.
PERSONS TO AVOID POSSIBLE INJURY.
KEEP ALL FRAME CONNECTIONS LOOSE, UNTIL INSTRUCTED IN THE ASSEMI
SEQUENCES TO SECURELY TIGHTEN. ""
¯
IF YOU EXPERIENCE ANY PROBLEM WITFL T,'HE ASSEMBLYOF THIS PRODUC'-r,
CONTACT YOUR DEALER OR YOUR PARABODY CUSTOMER SERVICE
¯
TOOLS
REQUIRED:
RATCHET, 3/4 SOC ..K~or WKENCH, 9/16 SOCKETor.WRt""
ADJUSTABLE WRENCH. $/32 ALLEN WRENCH, and RUBBER MALL~'T or HAMMER ";
*** REFER TO ASSEMBLY DRAWING #1 FOR STEPS 1THRU 13 ***
Bolt HEAD XVEIGHT PLATE into the threaded hole at top of SELECT CENTER SHAF'T, using one
(I } 3 ~ X I-1 2 IN. FlEX FlEAD BOLT. one (l) 3.'8 IN. LOCK WASHER, and one (l) 3.'8 IN. WASHER
(SEE DETAIL DL
Put seven t7} 2 IN. SO. END .CAPS into ends of tubes on WEIGHT STACK SUPPORT BASE.
Attach one t I} 4-I 20.D. DIA. PULLEY with 1 IN. BUSHING to WEIGHT STACK SUPPORT BASE
using one ( I } ~ $ X 2 IN. HEX HEAD BOLT. one ( ! ) CABLE RETAINING "L" CLIP. a'.ad one (I) 3/8 IN.
LOCKNUT. (DO NOT TIGHTEN)
Insert t~o {2~ I 2 IN. FLANGE BEARINGS into tube on LOW ROW SWIVEL BRACKET_.
Attach LOW ROW SWIVEL BRACKET to YOKE on WEIGHT STACK SUPPORT BASE, using
one { 1 } ! 2 X 4 IN. I IEX HEAD BOLT. and one (!) 1.'2 IN. LOCK NUT. Tighten so it swivels freely, yet
doesn't ~vo.bble. ~
LOOSELY attach'one I I ~ .,t-l " O.D'.'DII-X. il . ) VEL
BRACKET. usin~ one ~ I ~ 3 ,~ X 2 IN. HEX HEAD BOLT and one t I ~ 3 8 IN. LOCKNU'['. (DO NOT
TIGHTEN}