General Troubleshooting - Baumatic BKDW45SS User Manual

This includes situations where appliances have been tiled in,
sealed in with sealant, have wooden obstructions placed in
front of the appliance, like plinths. Or any installation other
than the one specified by Baumatic Ltd. has been completed.
Please refer to the conditions of guarantee that appear on the
warranty card
IMPORTANT: Baumatic Ltd. operates a policy of continuous
improvement and reserves the right to adjust and modify its
products without prior notification.

General troubleshooting

Category Problem
Dishwasher
Technical
problems
Water not
dishwasher.
Suds in the
General
problems
Stained tub
29
that you receive
Possible causes
Fuse blown or the
circuit breaker
acted.
Power supply is not
turned on.
does not
start.
Water pressure is
low.
Door of dishwasher
not properly
closed.
Kink in the drain
hose.
Filter is clogged.
Kitchen sink is
pumped
clogged.
from
Improper detergent
used.
tub.
Spilled rinse-aid.
Detergent with
with the appliance.
What to do
Replace the fuse or reset the
circuit breaker. Remove any
other appliances sharing the
same circuit with the
dishwasher.
Make sure the dishwasher is
turned on and the door is
closed securely.
Make sure the power cord is
properly plugged into the
wall socket.
Check that the water supply
is connected properly and
the water is turned on.
Make sure to close the door
properly and latch it.
Check the drain hose.
Check the coarse filter.
Check the kitchen sink to
make sure it is draining well.
If the problem is in the
kitchen sink and not the
draining, you may need a
plumber rather than an
authorised service agent.
Use only the specific
dishwasher detergent
amount to avoid suds. If this
occurs, open the dishwasher
and let the suds evaporate.
Add 1 gallon of cold water to
the tub. Close and latch the
dishwasher door then start
the SOAK wash cycle to
drain out the water. Repeat
if necessary.
Always wipe up rinse-aid
spills immediately.
Make sure that the