Baumatic BKDW45SS User Manual page 28

Intensive indicator light flashes
o The machine has sensed water in the base.
Check that the outlet hose is not kinked or crushed.
Check that there are no blockages in the drain hose or the drainage
system that the appliance is connected to.
The drain pipe may be placed in too high a position or incorrectly.
Check the installation instructions and ensure that the installation is
correct.
Intensive and normal indicator lights flash
o Short circuit
Thermistor
Call an Authorised Service Agent.
Intensive, normal and eco indicator lights flash
o Open circuit
Thermistor
Call an Authorised Service Agent.
IMPORTANT: If any other combinations of the program
indicator lights flash, you should not attempt to clear it
yourself and contact an Authorised Service Agent..
IF THE FAULT CODE REAPPEARS AFTER FOLLOWING
THE ABOVE ADVICE AND CLEARING THE FAULT
CODE. YOU SHOULD TURN OFF THE APPLIANCE;
DISCONNECT THE APPLIANCE FROM YOUR MAINS
SUPPLY. THEN ARRANGE FOR AN ENGINEER TO
ATTEND THE APPLIANCE. YOU SHOULD CONTACT AN
AUTHORISED
WWW.APPLICO.CO.NZ
NEAREST TO YOU.
Please note that if an engineer is asked to attend whilst the product is
under guarantee and finds that the problem is not the result of an
appliance fault, then you may be liable for the cost of the call out
charge.
The appliance must be accessible for the engineer to perform
any necessary repair. If your appliance is installed in such a
way that an engineer is concerned that damage will be caused
to the appliance or your kitchen, then he will not complete a
repair.
28
SERVICE AGENT.
TO LOCATE A SERVICE AGENT
LOG ONTO