Table of Contents
Advertisement
General troubleshooting
The appliance does
not start
Routine formation of
suds
The appliance shuts
down during the
wash cycle.
A whining sound can
be heard during the
wash cycle.
Noise during cycle.
Beating sound of the
inlet valve whilst
filling with water.
Spray arm is
struggling to rotate.
Water is left in the
appliance at the end
of the wash cycle.
The door is difficult
to close.
Downloaded from DishWasher-Manual.com Manuals
Start up problems
The socket does not work.
The appliance is not properly connected.
The dishwasher is not properly closed.
The water tap is closed.
There is no water supply to the property.
Insufficient water system pressure.
Inlet hose is kinked or crushed.
Filter for outlet hose or solenoid valve is blocked.
All necessary operations to start the dishwasher have
not been performed.
Fuse in the plug has blown or there is a problem with
the mains supply.
Dishwasher LED display is showing an error code.
Problems during wash cycle
Loading error, there is wash detergent in the rinse aid
dispenser.
Rinse aid liquid spread over the inner door liner. After
filling with rinse aid, remove any excess rinse aid with a
damp cloth.
Power cut
No water in appliance.
A whining sound coming from the pump is not
significant. There may be too much detergent or a
detergent without phosphates. If the problem persists,
then contact the Customer Care Department.
The spray arm is striking dishes.
Dishes have not been properly arranged in the basket.
Generated by water distribution, it has no effect on the
mechanical operation of the appliance. This type of noise
is unavoidable.
The spray arm is blocked by some food residue and
should be cleaned.
The drain hose is kinked or blocked.
The drain pump has jammed.
The filters in the base of the appliance are dirty and/or
filled with residue.
The appliance is not fitted correctly into the aperture.
Dishes are coming into contact with the door gasket.
35
Advertisement
Table of Contents
