Safety Instruction - iSolution FOLL02 User Manual

1. Safety Instruction

Please read the instruction carefully which includes important
information about installation, operation and maintenance.
WARNING
♦
Please keep this User Guide for future consultation. If you sell the unit to another user,
be sure that they also receive this user guide.
♦
Unpack and check carefully there is no transportation damage before using the unit.
♦
Before operating, ensure that the voltage and frequency of power supply match the
power requirements of the unit.
♦
It's important to ground the yellow/green conductor to earth in order to avoid electric
shock.
♦
The unit is for indoor use only and only in a dry location.
♦
The unit must be installed in a location with adequate ventilation, at least 50 cm from
adjacent surfaces. Be sure that no ventilation slots are blocked.
♦
Disconnect main power before fuse/lamp replacement or servicing.
♦
Replace fuse/lamp only with the same type. Do not use any other type of lamp.
♦
Make sure there are no flammable materials close to the unit while operating as it is
fire hazard.
♦
Use safety cable when fixes this unit. Don't handle the unit by taking its head only, but
always by taking its base.
♦
Maximum ambient temperature is TA: 40℃. Don't operate it where the temperature is
higher than this.
♦
Unit surface temperature may reach up to 85℃. Don't touch the housing bare-hand
during its operation. Turn off the power and allow about 15 minutes for the unit to cool
down before replacing bulb or serving as the unit could be very hot.
♦
In the event of serious operating problem, stop using the unit immediately. Never try to
repair the unit by yourself. Repairs carried out by unskilled people can lead to damage
or malfunction. Please contact the nearest authorized technical assistance center.
Always use the same type spare parts.
♦
Don't connect the device to any dimmer pack or power pack.
♦
Do not touch any wire during operation as high voltage might be causing electric
shock.
2F
• Warning
♦
To prevent or reduce the risk of electrical shock or fire, do not expose the unit to rain or
moisture.
♦
Never touch bulb with bare fingers as it is very hot after using.
♦
Hot lamp explosion hazard. Do not open the unit within five minutes after switching off.
♦
Do not start on the unit without bulb enclosure or housing are damaged.
♦
The housing, the lenses, or the ultraviolet filter must be replaced if they are visibly
damaged.
♦
Do not look directly at the light while the bulb is on.
• Caution
There are no user serviceable parts inside the unit. Do not open the housing or attempt any
repairs by yourself. If you need any service, please contact your nearest dealer.
• Installation
The unit should be mounted via its mounting system (as show below). Always ensure that
the unit is firmly fixed to avoid vibration and slipping while operating. Always ensure that the
structure to which you are attaching the unit is secure and is able to support a weight of 80
kgs for each unit.
3F