Advertisement
before calling for service
Problem
Dishwasher won't start
Dishwasher beeps at the
end of the cycle
Rinse Aid light on
Dishwasher operates too
long
Dishes are not clean
enough
Dishes not drying enough
Spots and filming on
dishes
Etching
Detergent left in
dispenser cup
Troubleshooting
Possible cause
Door may not be closed properly
Power supply or power line is not connected
Delay Start option has been selected
Child Lock activated (selected models)
It indicates the wash cycle finished, the
dishwasher will beep
The rinse aid level is low
The dishwasher is connected to cold water
The cycle time will vary due to the soil
The sanitize option is selected
Water pressure is temporarily low
The inlet water is low
Dishes are loaded too close together
improper use of detergent
The selected cycle is not suitable for food soil condition
Spay arms blocked by some items
Detergent dispenser is empty
Improper loading of dishes
The cycle you chose did not included the drying.
Water hardness is too high
Improper loading of dishes
Old or damp powder rinse aid is used
Rinse dispenser empty
Using too much detergent
The inlet water temperature exceeds 150 ℉
Detergent may be too old
Spray arm is blocked
16
Solution
Shut the door completely make sure it is latched
Check and connect the power supply
Refer to "Delay Start" section in this manual to rese
Deactivate the child lock, refer to child lock
section in this manual
Add rinse aid
Check the dishwasher, make sure it connected
to the hot water supply
When heavy soil is detected, the auto, normal,
pots&pan cycle will automatically increase the
cycle time
When sanitize option is selected, the cycle time
will be increase to meet the sanitized
temperature request
Use you dishwasher when the water pressure is
normal
Make sure the dishwasher is connected to the
hot water supply
Try not use your dishwasher when hot water is
being used elsewhere in the house
Load the dishes again as the manual introduced
Add detergent depending on the water hardness
and the cycle you chose. Use fresh detergent.
Choose anther cycle for longer washing time
Make sure the spay arm
can
rotate
Fill rinse aid dispenser or increase the amount
of rinse aid.
Load the dishes again as the manual introduction
Choose the proper cycle with drying
For extremely hard water install
a water softener
Load the dishes again as the manual indicates
Use fresh rinse aid
Add rinse aid to the dispenser
Use less detergent if you have soft water
Lower the inlet water temperature
Use fresh detergent
Load
the dishes, making sure the spray arms
are not blocked.
f reely
Advertisement
