Table of Contents
Advertisement
HCD-CL5MD
4-1. PRECAUTIONS FOR USE OF TEST MODE
• As loading related operations will be performed regardless of the test mode operations being performed, be sure to check that the disc
is stopped before setting and removing it.
Even if the Z button is pressed while the disc is rotating during continuous playback, continuous recording, etc., the disc will not stop
rotating.
Therefore, it will be ejected while rotating.
Be sure to press the MENU/NO button, and press the Z button after the disc stops rotating.
4-1-1. Recording laser emission mode and operating buttons
• Continuous recording mode (CREC 1MODE) (C35)
• Laser power check mode (LDPWR CHECK) (C13)
• Laser power adjustment mode (LDPWR ADJUS) (C04)
• Iop check (Iop Compare) (C27)
• Iop value nonvolatile writing (Iop NV Save) (C06)
• Traverse (MO) check (EF MO CHECK) (C14)
• Traverse (MO) adjustment (EF MO ADJUS) (C07)
• When pressing the MD REC button.
4-2. SETTING THE TEST MODE
The following are two methods of entering the test mode.
Procedure: Connect the mains lead to the mains while pressing the DIMMER , FUNCTION , and x buttons together, then release the
DIMMER , FUNCTION , and x buttons simultaneously.
When the test mode is set, "[Check]" will be displayed. Move ./> to switch between the following three groups;
··· y Check y Service y Develop y ···.
NOTE: Do not use the test mode in the [Develop] group.
If used, the unit may not operate normally.
If the [Develop] group is set accidentally, press the MENU/NO button, immediately to exit the [Develop] group.
4-3. EXITING THE TEST MODE
Press the REPEAT button. The disc is ejected when loaded, and "Initialize" display blinks, and the STANDBY state is set.
4-4. BASIC OPERATIONS OF THE TEST MODE
Operate using the ./> , ENTER/YES button, REC MODE button, MENU/NO button.
Function name
MENU/NO button
ENTER/YES button
./> (Left or Right)
REC MODE button
26
Function
Cancel or move to top hierarchy
Set
Select
Set submenu
Advertisement
Table of Contents
