Table of Contents
Advertisement
by your ISP.
Primary
If you plan to use the DFL-1000 as a DHCP server to assign IP addresses to the computers on
5. DHCP Server
your internal network, you must specify the IP address range reserved to be assigned by the
(optional)
DHCP server.
Starting IP
Choose virus protection levels to protect your internal network from viruses. You can set high,
6. Anti-Virus
medium, and low protection for web traffic (HTTP), and email traffic (SMTP, POP3, and IMAP).
(optional)
For information on high, medium, and low protection, see
HTTP
High
SMTP
High
POP3
High
IMAP
High
7. DMZ Interface
In the space below, record the IP address and netmask to connect the DFL-1000 to your DMZ
(Optional)
network.
IP
* The Internal and External IP addresses must be on separate subnets.
Transparent Mode Install
Use
Transparent mode configuration information
1000 to run in Transparent mode.
Transparent mode configuration information
Specify an administrator password. The password should be difficult to guess. It must be at
1. Administrator
least 6 characters long and may contain numbers (0-9) and upper and lower case letters (A-Z,
Password
a-z), but no spaces.
In the space below, record the IP address and netmask to connect the DFL-1000 to a network
for management. Management can be done from a computer on your internal network or from
2. Transparent
a separate network.
Management IP
Also record the IP address of the default gateway required to connect the DFL-1000 to a
network for management. The default gateway address is not required if the management
computer can be reached without going through a default gateway.
Management IP
Default Gateway
In the space below, record the IP addresses of the primary and secondary DNS servers
3. DNS Server
provided by your ISP.
Primary
DFL-1000 User's Manual
Secondary
Ending IP
Medium
Medium
Medium
Medium
Netmask
to collect the information required to configure the DFL-
Netmask
Secondary
Virus
protection.
Low
Low
Low
Low
16
Advertisement
Table of Contents
