Buell 2008 XB SERIES Electrical Diagnostics Manual page 110

Engine Temperature Sensor: DTC P0117 (14); DTC P0118 (14) (Part 1 of 2)
2-60 2008 Buell XB Diagnostics: Engine Management
Disconnect ET Sensor connector [90]. Measure resistance
between [90A] and body of ET Sensor.
Is resistance between 33761-74328 ohms, when engine
temperature ranges 68-86
YES
Attach Breakout Box (B-48115) to the
1
Electronic Control Module (ECM). Using a
DVOM (Part No. HD-39978), measure the
2
resistance between ET Sensor connector
and ECM connector [11] terminal "11".
*
Is it less than 1.0 ohm?
YES
Using a DVOM, measure the resistance
between Breakout Box terminal "11" of
*
[11] and Ground.
Is it greater than 1.0 megaohm?
YES
STOP
Go To Engine
Temperature Sensor
Test DTC P0117 (14);
P0118 (14) (Part 2 of 2)
At some point in the flow chart you may
*
be instructed to jump directly to a the
box with the bold asterisk. Disregard
the asterisk (but not the instruction
box) if your normal progression through
the chart brings you to this location.
o o
F (20-30 C)?
Sensor. See
the appropriate
Buell Service
Examine (PK/Y)
wire in harness for
open circuit and
Examine harness for
short to ground and
Clear DTCs and confirm proper
operation with no check engine
lamp. Codes can be cleared
using DIGITAL TECHNICIAN
(Part No. HD-44750).
NO
Replace ET
Manual.
NO
repair.
NO
repair.
fc00395_en