Head Unit Installation; Test Of Installation - Vetta c-500 Owner's Manual

HEAD UNIT INSTALLATION

TEST OF INSTALLATION

Once you have finished with the installation procedure, you are ready to test the unit to make sure that it works.
STEP 1
Advance the computer to the speedometer mode.
STEP 2
Pick up the front of the bicycle and spin the front wheel. The computer should register speed within 1-2 seconds.
If you do not get a speed reading, check to be sure that the magnet and sensor alignment is correct and that
the space between the magnet and sensor is 1-2mm or less. If this does not solve the problem, call the Vetta
customer service hotline at 1.800.GO.VETTA.
The heads of all Vetta computers are designed to lock into their brackets.
When installing your computer head into the bracket you should hear an
"SNAP"
audible indicating that the unit is locked firmly in place. The head of
the C-500 will slide into the bracket from the back to the front, this feature
keeps the unit from inadvertently being pushed out of the bracket during
normal use.
CAUTION Because the C-500 is a wireless cycle computer, it will operate
!
without being fully secured in the bracket. BE SURE THAT THE HEAD IS
FULLY LOCKED IN PLACE IN THE BRACKET BEFORE USING THE UNIT.