Rf Tests; Receiver Tests - Motorola MTH500 Basic Service Manual

3. Press "Traffic Channel" soft key. Enter "3700" for R1 and "900" for R2 and
4. Press "RF Gen Level" soft key. Thereafter, enter "-50" and press "dBm" data
5. Press "Mobile Power" soft key, enter 30 dBm/1W, using soft key.
6. Press "Burst Type" soft key and "Normal" soft key.
7. This completes the test equipment configuration setup.
Note: The System Setup Configuration Data is saved even after the power is

RF Tests

Receiver Tests

Simulate Base Station (registration)
1. Turn the radio ON
2. Check that registration and "ITSI: ---/----/00000xxx" is displayed on the IFR
Status: Registered (ITSI Attach)
RSSI Test
Before carrying out the following steps, record the Insertion loss (dB) of the cable
loss value - (X) dB. Also, 0.5 dB, the maximum insertion loss of the Antenna
assembly adapter should be added to the total calculated insertion loss.
1. In the IFR Manual Test Mode, press the "RF Gen Level" Soft Key and enter
12
press "Traffic Channel" soft key. The marker goes to Timeslot. Enter "3" and
press "Traffic Channel" soft key. (Note that the Traffic Channel number
changes automatically after entering the Control Channel number).
keys followed by "RF Gen Level" soft key.
turned off. However, the Manual Test Setup is not saved.
"Manual Test" screen.
(–) 80dbm.
TEST SETUP & TESTING: RF Tests