S_Irq; Clr_Cmos - Fujitsu GA-8STXC User Manual

16) S_IRQ (Serial IRQ Connector)
1
17) IR
1
VCC(+5V)
18) CI (CASE OPEN)
1
19) CLR_CMOS (Clear CMOS)#
1
1
GA-8STXC Motherboard
This Manual: http://www.manuallib.com/file/2597476
GND
Signal
IR Data Output
N C
GND
IR Data Input
GND
Signal
1-2 close: Normal
2-3 close: Clear CMOS
This connector is for special design,
for example: PCMCIA add on card.
Please make sure that pin 1 on the IR device
is align with pin 1 of the connector. To enable
the IR function on the board, you are required
to purchase an option IR module. For more
detail information please contact your nearest
dealer for optional IR device.
This 2 pin connector allows your system to
enable or disable the system alarm if the
system case begin remove.
You may clear the CMOS data to its default
values by this jumper. To clear CMOS, tem-
porarily short 1-2 pin.
- 20 -