Samsung AR09KSFPDWQN User Manual page 33

trucks, scaffolding or any other means of elevation
to end user.
This equipment complies with FCC and IC RSS-102
radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and
operated with minimum distance 6" (7.87inch(20cm))
between the radiator & your body.Any changes
or modifications not expressly approved by the
This device complies with Industry Canada licence-
exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause
harmful interference and (2) this device must accept
any interference received, including interference that
may cause undesired operation.
This Class B digital apparatus complies with Canadian
ICES-003
When installing the outdoor unit at the seaside, make
sure that it is not directly exposed to sea breeze. If
you cannot find an adequate place free from direct
sea breeze, construct a protection wall or a protective
fence.
– Install the outdoor unit in a place (such as near
buildings etc.) where it can be protected from sea
breeze. Failure to do so may cause a damage to the
outdoor unit.
Sea breeze
Sea Outdoor unit
If you cannot avoid installing the outdoor unit at the
seaside, construct a protection wall around to block the
sea breeze.
Construct a protection wall with a solid material such
as concrete to block the sea breeze. Make sure that
the height and the width of the wall are 1.5 times
larger than the size of the outdoor unit. Also, secure
a space larger than 23.6inch(600 mm) between the
protection wall and the outdoor unit for exhausted air
to ventilate.
32 English
Sea breeze
Outdoor unit
Sea
Sea breeze
Sea
Protection wall
Install the unit in a place where water can drain
smoothly.
If you have any difficulty finding installation location
as prescribed above, contact your manufacturer for
details.
Be sure to clean the sea water and the dust on the heat
exchanger of the outdoor unit and apply a corrosion
inhibitor on it. (At least once in a year.)
Power supply line, fuse, or circuit
breaker
Always make sure that the power supply is compliant
with current safety standards. Always install the air
conditioner in compliance with current local safety
standards.
Always verify that a suitable grounding connection is
available.
Verify that the voltage and frequency of the power
supply comply with the specifications and that the
installed power is sufficient to ensure the operation of
any other domestic appliance connected to the same
electric lines.
Always verify that the cut-off and protection switches
are suitably dimensioned.
Verify that the air conditioner is connected to the
power supply in accordance with the instructions
provided in the wiring diagram included in the manual.
Always verify that electric connections (cable entry,
section of leads, protections...) are compliant with
the electric specifications and with the instructions
provided in the wiring scheme. Always verify that all
connections comply with the standards applicable to
the installation of air conditioners.
Use Copper Supply Wires.
Protection wall
Outdoor unit
Outdoor unit