Properties; Digital Electronic Module 2Do Dc24V/2A Hf (6Es7132-4Bb31-0Ab0) - Siemens SIMATIC ET 200S Manual

Properties

1.1

Digital electronic module 2DO DC24V/2A HF (6ES7132-4BB31-0AB0)

Properties
● Digital electronic module with two outputs
● Output current 2 A per output
● Rated load voltage 24 VDC
● Diagnostics: Wire break
● Diagnostics: Short circuit
● Short-circuit protection
● Suitable for solenoid valves, DC contactors, and indicator lights
● Supports isochronous operation
● Extended temperature range from 0 to 55 °C with vertical installation
Peculiarity
When you connect the 24 VDC rated load voltage to the power module by means of a
mechanical contact, depending on the circuit the digital outputs carry the "1" signal for
approximately 50 µs. You need to take this into account if you connect the module to fast
counters.
General terminal assignment
Note
Terminals 4, 8, A4, A8, A3 and A7 are only available at specified terminal modules.
Terminal Assignment Terminal
1 DO
0
2 L+
3 M
4 n.c.
A4 AUX1
A3 AUX1
Digital electronic module 2DO DC24V/2A HF (6ES7132-4BB31-0AB0)
Manual, 04/2007, A5E01077255-01
Terminal assignment for 2DO 24 VDC/2 A HF (6ES7132-4BB31-0AA0)
Assignment
5 DO
1
6 L+
7 M
8 n.c.
A8 AUX1
A7 AUX1
DO : Output signal, Channel n
•
n
L+: Rated load voltage 24 VDC
•
M: Ground
•
n.c.: Not connected (max. 30 V DC can be connected)
•
AUX1: Protective-conductor terminal or potential bus (freely usable
•
up to 230 VAC)
Notes
1
7