GRE BC3800 Instruction Manual page 5

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
When the temperature in the pool is 1°C lower than the "Set" Temp., the heat pump will start
again.
Cooling Only Mode : (+ 2/ - 0°C '' from set point '' )
This works the same way, but will only cool when the temperature exceeds the cooling
"Set" Temp. by 2°C and it will cool down to the "Set" Temp.
Remember that the highest Cooling "Set" Temperature is 37°C.
Auto Mode : (''Automatically Heating Mode or Cooling Mode'' )
In Auto Mode your heat pump will try to keep your desired pool temperature at all times.
Example :
If you want your pool to be 30°C:
a. If the pool-water is below 29°C the heat pump will start heating.
b. When the temperature reaches 31°C the heat pump will stop.
c. If the temperature in your pool continues to rise, and passes 32°C, the heat pump will
start again, BUT in Cooling Mode, and cool down to 30°C.
d. If now the temperature continues to drop, and it drops below 29°C, the heat pump will
start again, BUT in Heating Mode.
In Auto Mode the heat pump will try to keep the temperature within 2°C higher and 1°C
lower that your "Set" Point.
(Remember that the filter pump has to run in order for the heat pump to work)
2).How to set using the display controller :
a. First select the desired mode: auto, heating or cooling
b. Regardless if the heat pump is "running" or in "standby" press ▲ or ▼.
The display will show the currently set water temperature of the selected mode with a flashing number:
While it is blinking you can change the water temperature by pressing ▲ or ▼ to the temperature you
want.
(Before you select the desired temperature, make sure you are in the correct mode: Heating / Cooling /
Auto.)
After you see the desired temperature blinking, wait 5 sec. and the temperature is stored.
Cooling Mode
Range 8 - 28℃
6. How to check parameter settings and measured values of current status
Regardless whether the heat pump is "running" or in "standby" press MODE for 5 sec.
The display will start to blink (both digits)
Heating Mode
Range 15 - 40℃
- 5 -
Auto Mode
Range 8 - 40℃

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bc21000Bc4500Bc9000Bc13000

Table of Contents