Tv Operating Mode - Promax TV EXPLORER HD User Manual

TV EXPLORER HD / HD
USER'S MANUAL.

5.24 TV Operating Mode

When pressing the
HD / HD
accedes to the
LE
video signal on tune.
In the monitor will appear the TV picture with a window on the lower part to show,
for five seconds whenever the signal is analogue; the channel number, the frequency,
the active channel set, the colour system, the TV standard and the saturation level
(SYNC OK / SYNC FAIL).
If it is a digital television signal (
the following parameters:
The top data box shows the tuned
frequency, active channel plan and satellite downlink frequency.
The following data box shows the
MPEG-4), video bit rate, profile and level with its resolution and aspect ratio, video
VPID
program identifier (
Next data box contains
MPEG-2, AAC or DD), audio bit rate, audio program identifier (
spa).
The last box located in the same column shows the
name and/or satellite orbital position, service name, network identifier (
SID
identifier ( ) and logical channel number (LCN) assigned (if DVB-T is selected).
10/2012
LE
[10] key from any mode of operation the
TV mode
, and tries to demodules on the monitor the currently
Figure 65.-
Analogue channel monitoring.
DTV
) on screen appears, for about some seconds,
CHANNEL
VIDEO
) and the TS identifier (
AUDIO
information: type of audio coding (MPEG-1,
data: number or satellite name,
data: type of video coding (MPEG-2 or
TSID
).
APID
) and language (e.g.
NETWORK
TV EXPLORER
data: network
NID
), service
Page 91