Panasonic AJ-D440 Operating Instructions Manual page 40

Setup menus
USER menu
<VIDEO>
No.
606
608
611
612
613
614
The underline on the setting item denotes the initial setting.
(continued)
Item Setting
Superimposed Superimposed
No.
display display
CC (F2) 0000
BLANK 0001
FREEZE 0000
SEL 0001 FRAME
EDH 0000
0001
WIDE 0000
SELECT 0001
0002 NORMAL
VIN SETUP 0000
0001
VOUT 0000
SETUP 0001
– 40 –
This selects ON or OFF for the closed capture signal in the
BLANK
second field.
THRU
0:
Forced blanking performed.
1:
Blanking not performed.
This selects the freeze mode for still pictures.
FIELD
0:
Field freeze
1:
Frame freeze
<Note>
When frame freeze is selected, the frame freeze mode is
established even during slow motion.
This selects whether to superimpose EDH onto the serial
OFF
output signals.
ON
0: EDH is not superimposed.
1:
EDH is superimposed.
• This item setting is valid when the optional serial interface
board has been installed.
This selects the operation to be conducted in response to the
AUTO
WIDE information.
WIDE
0: During recording, if the Y/C input signals contain WIDE
information, the WIDE information is recorded on the tape.
During playback, if WIDE information is on the tape, it is
added to the Y/C output signals.
1:
During recording, the WIDE information is recorded on the
tape regardless of whether the Y/C input signals contain
the WIDE information.
During playback, the WIDE information is added to the
Y/C output signals regardless of whether the WIDE
information is on the tape.
2:
During recording, the WIDE information is not recorded on
the tape regardless of whether the Y/C input signals
contain the WIDE information.
During playback, the WIDE information is not added to the
Y/C output signals regardless of whether the WIDE
information is on the tape.
<Note>
This item is effective during recording at the start of the
recording and during playback at all times. Therefore, when
its setting has been changed during recording, the MENU
contents will be changed but no change will occur in the
actual operation.
This selects whether the composite signal is to be recorded
THRU
with setup or without setup.
CUT
0:
When recording signals with no setup.
1:
When recording signals with 7.5% setup.
<Note>
When recording composite signals, be sure to double-check
whether the signals are to be recorded with or without setup.
This selects the composite output signal.
THRU
0:
The signal is output without setup.
ADD
1:
Ths signal is output with 7.5% setup.
Description
Forced WIDE ON
Forced WIDE OFF